Next: Tracepoint Passcounts, Previous: Create and Delete Tracepoints, Up: Set Tracepoints [Contents][Index]
These commands are deprecated; they are equivalent to plain disable and enable.
disable tracepoint [num]Disable tracepoint num, or all tracepoints if no argument
num is given. A disabled tracepoint will have no effect during
a trace experiment, but it is not forgotten. You can re-enable
a disabled tracepoint using the enable tracepoint command.
If the command is issued during a trace experiment and the debug target
has support for disabling tracepoints during a trace experiment, then the
change will be effective immediately. Otherwise, it will be applied to the
next trace experiment.
enable tracepoint [num]Enable tracepoint num, or all tracepoints. If this command is issued during a trace experiment and the debug target supports enabling tracepoints during a trace experiment, then the enabled tracepoints will become effective immediately. Otherwise, they will become effective the next time a trace experiment is run.